Product Description:
self-adhesive bitumen waterproof membrane are produced with SBS elastomer and bitumen as raw materials, using polyethylene film.Aluminium foil coated on the upward or no file(both side self-adhesive) while self-adhesive protection layer on the downward surface.It has a widely prospect new contruction waterproof materials. Good self-adhesion, no leaking,cold flexibility,especially in self-adhesion. That is unque product in waterproof and application.
Advantages:
1). Self-adhesion without bonding agent, torching
2). Good rubber elasticity and elongation
3). Excellent adhensiion bond
4). Safe application, no pollution
5). Excellent waterproof and high strength
6). Corrosion resistance and ageing-resistance
7). Available for wet ground
Technical data
NO. | PROGRAM | STANDARD | TEST | RESULT | |||
1 | ROLLS AREA,% | ≥99% | PASS | PASS | |||
2 | Kg/square meter | ≥1.85 | 2.0 | 2.0 | |||
3 | THICKNESS | AVG | ≥1.50 | 1.51 | 1.50 | ||
MIN | ≥1.35 | 1.45 | 1.50 | ||||
4 | FACADE | PERMEABILITY | NO PENETRATIVE SPOTS | / | NO SPOTS | ||
SURFACE | SMOOTH,NO HOLE,NO SHORT | / | MEET STANDARD | ||||
5 | PHYSICS PERFORMANCE | IMPERVIOUSNESS | ≥ 120 min | ≥0.3 Mpa | IMPERVIOUS | ||
MAX TEMPERATURE | NO AIRBELLS,NO SLIP | 80 ºC/240 min | NO-SLIP | ||||
PULL N/50mm | LONGITUDINAL | ≥200N | 230.65 | MEET STANDARD | |||
LATERAL | ≥200N | 212.30 | MEET STANDARD | ||||
ELONGATION | LONGITUDINAL | ≥30% | 90% | MEET STANDARD | |||
LATERAL | ≥30% | 90% | MEET STANDARD | ||||
LOW TEMPERATURE | NO CRACK | -29ºC/240min | NO CRACK | ||||
6 | PACKAGE AND MARK | Mark should complete,use artwork or shrink warp in rolls. |
Construction and other base face is simple, clean, and can be widely used in roofing, basement, bathroom, etc. waterproofing works, and for legislation to pave and stick and pipe wall (except heat pipes), bridges , and other complex environment, especially in open flame is prohibited, covert fire waterproofing works.
Do not apply to very cold frosted surfaces. Trim the materials to the required length/shape allowing an overlap of at least 25 cm where the material is to be joined.On stepped flashing begin at the lowest level and work upwards.
Warming the tape using gentle indirect heat will help the adhesion and make the tape more workable in cold temperatures.Ensure that there are no air pockets.Apply even pressure over the entire surface using a non-abrasive tool e.g. cloth or hand roller.Take care not to stretch or puncture the foil during application.