10W rechargeable work light with power bank
| ITEM NO | BMSL1299 |
|---|
| Size | 14.5 x 14.5 x 4 cm |
| Material | plastic |
| Weight | 290g |
| Power | 10W |
| Brightness | 2 power levels:270lumen and 550lumen |
| Battery | 4*AA excluded |
| Working time | 3-4hours |
Usage instructions
Charging the rechargeable battery
1. Insert the round connector of the charger in the charging slot in the handle of the worklight.
2. Connect the charger with the mains. The charging light will illuminate in red and the rechargeable battery will be charged.
3. Disconnect the worklight from the mains after it has charged. The charging light will turn green once the rechargeable battery has been fully charged.
· The parts of the worklight can be charged individually or in a connected state.
· To make sure that both parts of the worklight light up uniformly, charge the worklight once the parts have been connected.
Operation
You can operate the worklight as follows:
1. Push the On/Off switch once to operate the worklight n in the brightest mode (100 %).
2. Push the On/Off switch twice to operate the worklight with lower light intensity (50 % mode).
3. To turn off the worklight, push the 0n/0ff switch again.
The luminous period of the worklight amounts to approx. 2 hours if the rechargeable batteries are fully charged.
Connecting/disconnecting the worklights
Connecting the worklights
1. Take one worklight in your left hand and the second worklight in your right hand.
2. Insert the plastic nubs on the front part of the one worklight into the recesses a on the front part of the second worklight. It doesn’t matter which of the worklights is in which hand.
3. Make sure that the arrows on the front part of the worklights are aligned so that the worklight forms a continuous strip once connected.
4. Turn left with your right hand and at the same time turn right with your left hand to connect the worklights using the click mechanism.
Hold the worklights by the light strip and not by the handle when connecting them. This will reduce the leverage so you can connect the worklights easier.
Disconnecting the worklights
1. To disconnect the worklights that are connected with one another, take hold of the worklights in your hand.
2. Turn to the right with your right hand while turning to the left with your left hand.
It doesn't matter which of the worklights is in which hand. The click connection will be released.
